Bathtub Splash Guard

Keep bath time mess-free with this clever splash guard.

Designed by a parent, this simple guard helps prevent water from splashing over the tub's edge and onto your floor. The low-profile shape blends into most bathrooms, and the rounded edges make it kid-safe and easy to wipe clean.

• Stops splashes: Helps keep water in the tub and floors drier.
• Kid-safe edges: Smooth, rounded corners for safer everyday use.
• Quick install: Mount with caulk or strong double-sided tape.
• Clean look: Low-profile design fits most bathroom styles.

Install in minutes

1. Clean the surface: Dry and clean the tub edge and adjoining wall where the guard will sit.
2. Test placement: Position the guard to block the main splash path.
3. Mount it: Apply caulk or double-sided tape and press firmly into place.
4. Let it set: Allow caulk or tape to cure per the manufacturer’s instructions before getting it wet.

Tip: If you use tape, pick one rated for humid environments and plastics for best long-term hold.

What's included

• 1x Printed bathtub splash guard
• No adhesive included

Printed in small batches. Once this run sells out, the next batch may change based on feedback from our crew.

Fit & requirements

• You'll need: Bathroom-safe caulk or strong double-sided tape (not included).
• Works best with: Smooth, clean tub surfaces and a flat adjoining wall area.
• Fit check: Confirm you have enough flat contact area on the tub edge and wall for the guard to bond securely.
• Not ideal for: Rough or peeling surfaces, dusty/soapy residue, or areas where water can sit behind the guard.

Specs

Care

• Cleaning: Wipe clean with a soft cloth and mild soap as needed. Avoid abrasive scrubbers.
• Wet areas: Safe for wet environments when installed properly and allowed to fully cure.
• Heat: Avoid prolonged extreme heat or direct heat sources.

3D-printed parts may show subtle layer lines and minor cosmetic variation. Adhesive is not included. Installation surfaces must be clean and dry for best results.