Dog Waste Bag Dispenser (Standard Rolls)

Grab waste bags on the go with a clean, clip-on dispenser that stays out of your pockets.

This compact, two-part dispenser keeps a standard roll of dog waste bags neat and easy to access on walks. Glue the halves together for a permanent assembly, then clip it to a leash, belt, backpack, or key ring so you always have a bag ready.

• Walk-ready: Clips to your leash or gear so bags are always within reach.
• Clean feed: Guides the first bag through for quick pulls and easy tearing.
• Secure build: Two-piece design is made for a permanent glue-up.
• Fits standard rolls: Works with most common dog waste bag refills.

How to use

1. Dry fit first: Test how the halves align before gluing.
2. Glue and assemble: Apply a small amount of glue to the mating surfaces, press together, and clamp if needed.
3. Let it cure: Allow full cure time per the glue manufacturer’s instructions.
4. Load the roll: Insert a roll, feed the first bag through the outlet, then clip the dispenser to your leash or gear.

Tip: A gel super glue or plastic-safe epoxy helps reduce squeeze-out and improves long-term durability.

What's included

• 2x Dispenser halves (glue required for assembly)

Printed in small batches. Once this run sells out, the next batch may change based on feedback from our crew.

Fit & requirements

• You’ll need: Glue for permanent assembly (not included).
• Works best with: Standard dog waste bag rolls.
• Fit check: If you use jumbo rolls, confirm the roll diameter fits before gluing.
• Color options: White, Black, or Custom (additional fee).
• Not ideal for: High-heat environments (hot cars, direct sun for long periods) or heavy impacts.

Specs

Care

• Cleaning: Rinse if dirty, then dry fully before storage.
• Heat: Avoid extreme temperatures and prolonged direct sunlight.
• Handling: Clip securely and avoid dropping onto hard surfaces.

3D-printed parts may show subtle layer lines and minor cosmetic variation. Glue is not included.